Step 1: Make sure the surface is clean, dry, and smooth (to ensure maximum adhesion, it is recommended you wash the wall down with sugar soap).
Step 2: No glues or pastes are needed. The print should be applied dry, onto a dry surface. However, if applying to plastic or glass, both surfaces will need to be wet, just with water which will help eliminate bubbles and make easier for aligning.
Step 3: If applying full coverage, check that the ceiling and adjoining walls are square, as this will affect the laying as you progress from left to right.
Step 4: Peel the paper backing, then working from the top left hand corner, line up the top edge with the top of the wall and left edge. Smooth the top and then work your way down.
A second person is recommended to line up the bottom/adjoining the left hand abutting wall.
Step 5: Once placed in position, smooth out with your hands or a soft cloth. If using your hands, make sure you have no rings or sharp objects in your hands as this will scratch the print.
Step 6: Repeat Step 4, matching the print on the right hand edge of the previous panel, all the way down, and then smooth out as you go.
Continue this procedure until complete.